How to rewire car stereo system

Use the diagram provided with the stereo as well as the diagram provided with the clip, to loosely connect each of the wires to the new adaptor. Once all of the wiring has been connected to their corresponding wires, you will need to make those connections permanent.

how to rewire car stereo system

This deterioration can often cause short circuits, possibly resulting in permanent damage to the stereo unit. If they are present, your stereo is held in place with spring clips. Push the stereo into place. Typically, if you have a wiring harness, this connection will be made when you connect the new stereo harnesses to the harnesses in the car.

Before you start turning the screwdriver and ripping into your dashboard, set aside time to plan out the entire installation process. Include your email address to get a message when this question is answered. David Woo has been an aspiring journalist and writer since 2008.

Make sure that you're confident that once you pull apart your dashboard you'll be able to fit it back together.

how to rewire car stereo system

You will not need to remove the bolt entirely, instead simply loosen it enough to pull the cable off of the terminal. Most auto parts stores sell trim panel removal tools for this purpose. Run the power wire through the fire wall look for pre-existing holes or routed wires that you can run it along.

Learn How To Install A Car Radio

Connect the output convertor if necessary. This typically includes two pry bars that can be inserted into either side of the stereo to remove it. Armed with your master plan, carefully remove the dashboard components surrounding your radio by removing any set screws or hex bolts securing the fairing and carefully pulling the component away from the vehicle.

Slowly slide the radio back into the opening in the center console of the vehicle while being careful not to apply too much pressure to the face of it.

how to rewire car stereo system

It should hardly move at all when properly secured. Enjoy your new system. Double check that all screws and trim pieces are securely in place. Unanswered Questions.