All of the glass in the car is original, which makes the adhesive holding the driver's side window in place almost as old as I am. You'll see there is a groove or spline that goes around the shaft as shown. To re-attach the window glass to the mechanism, wind the cable fully down, then up again one full turn of the winder.
Pop the door panel off using a thin, sturdy tool. Press down on the tool gently to pop the door panel out. A local Pep Boys had one for mine, but I did not need to buy it.
Make sure it does not kink. From the speaker panel you can see the window rail and the bolt that holds it when you undo that bolt you can move the window back into place in the rail.
Stop wasting time on YouTube and get serious! To remove the rack, undo the screws at its top and bottom and at the winder-handle boss. Eli Laurens is a ninth-grade physics teacher as well as a computer programmer and writer.
TurtleDog more. Though never fun, off track windows are a common automotive problem and can be easily fixed at home.My Window Won't Roll Up - Easy Fix - Project Comancheep
Removing or melting the blockage will allow the window to move. Include your email address to get a message when this question is answered.
Remove screws and bolts along the interior of the car door. Carefully roll up the window and roll it down and see if the window is connected or disconnected.
Tension the cable by moving the adjustable pulley. If you don't drive in cold or wet weather and keep your car in the garage constantly, this isn't a big deal.
Fixing a heated rear window There are a number of possi...
A typical cable-and-pulley-operated window regulator showing cable run.